PLC MODULE 1756-ENET Communication Module

PLC MODULE 1756-ENET Communication Module 

Slot Width:1-slot
Part Number/Catalog No.:1756-ENET
Brand:PLC MODULE
Communication Port:One (1) Ethernet; One (1) AUI Port
Ethernet Data Transfer speed:10 Mbps
Supported topologies:Linear
Supported functions:Scanner / Adapter; Messaging
Compatible Chassis:Series A and B: 1756-A4, -A7, -A10, -A13 Chassis
Compatible Power Supply:1756-PA72 and 1756-PB72

Lily is always online to serve you

About the PLC MODULE 1756-ENET Communication Module 

The PLC MODULE 1756-ENET is a  communication module. It is an EtherNet/IP (Ethernet Industrial Protocol) interface communication module. It has been discontinued by the company and replaced with new model number 1756-ENBT with the same specification. It supports general messaging, real-time I/O messaging, and the information exchange for applications like real-time control, time synchronization, and motion. The 1756-ENET also meats the CIP safety standard by allowing simultaneous transfer of safety and control data and diagnostics information. It uses advanced communication chips and physical media. The 1756-ENET Module has 100 Mbps EtherNet/IP communication rates and uses copper wire. It supports 128 Logix and 64 TCP/IP communication connections. It can support a maximum of 8 axes for integrated motion on the Ethernet/IP Network. It draws a 700 mA current at 5.1V DC and 3 mA at 24V DC. It has a maximum power dissipation of 3.7 W and thermal dissipation of 12.6 BTU/hr. It can be installed in any slot in the PLC Chassis. For wiring, it uses unshielded RJ45, category 5, twisted-pair cable connectors to interface with the controller. To operate an EtherNet/IP network, parameters such as IP address, Subnet mask, Gateway etc., must be defined. The 1756-ENET bridge has various functions like providing support for messaging, distributed I/O, and tags. It encapsulates messages within standard TCP/IP protocol. ControlNet and DeviceNet network protocols allow it to share a common application layer. It does not require any scheduling or routing table to store information. Other features include explicit protected mode, electronic keying, device level ring network, and parallel redundancy protocol network support.

The 1756-ENET is an Ethernet communication interface from PLC MODULE. This module is part of the PLC platform. It is one of the first generation  modules that is declared discontinued by the manufacturer in December 2020. This module comes with one (1) RJ-45 interface that supports Ethernet protocol and one (1) AUI port used for module maintenance and localized configuration.

Our service

1.   High quality

Recommended model

NOTE: Sales Plc Limited sells new and surplus products and develops channels to purchase such products. This site is not approved or endorsed by any of the listed manufacturers or trademarks.Our Company is not an authorized distributor, dealer or representative of the products displayed on this site.All product names, trademarks, brands and logos used on this site are the property of their respective owners.The description, illustration or sale of products under these names, trademarks, brands and logos is for identification purposes only and is not intended to indicate any affiliation with or authorization by any rights holder.